Groomiist Corded Fully Waterproof Hair Trimme...

Aligning blades on the clipper when the blade screws are loosened the bottom blade can be aligned with the top blade.Keep the screws tight after the blade is aligned.End of the top blade teeth should be 0.5mm to 1.0mm back from bottom blade.This is important so that the clipper doesnt cut too close or allow the moving cutter to touch the skin.Extreme left hand tooth of top blade must be covering or be to the left of the first small tooth of bottom blade.Extreme right hand tooth of top blade must be touching the big tooth on the bottom blade.Taper lever some clippers are equipped with an adjustable taper lever that changes the closeness of your cut.When the lever is in the uppermost position, the blades will give the closest cut.Pushing the lever downward gradually increases the cutting length.Power screw to adjust power, turn the power screw in clockwise direction until you hear a noise.Then, slowly turn the power screw out (counter clockwise) just until the noise stops.This is maximum power.The clattering when turning the machine on or off is of no consequence, the came for moderate heating and vibration.Oil do not attempt to adjust this clipper before oiling.The blades of your new clipper should be oiled every few haircuts.Simply place a few drops of oil on the teeth of the blades.Use only the oil included in the pack.Due to the high speed of your clipper, the correct type of oil must be used.Do not use hair oil, grease or any oil mixed with kerosene or any solvent as the solvent will evaporate and leave the thick oil, slowing down the bladesThe clipper oil is a very thin, natural oil which will not evaporate and will not slow down the blades.